Epoxy.com Product #893
Water Based Primer
Epoxy.com Product # 893is a fast drying, two-component waterbased epoxy primer for use with our polyurethane based deck coating systems and joint sealants. The product has low odor and is non flammable.
Composition: A Bisphenol A-Epichlorohydrin epoxy resin cured with a modified amido amine.
Basic Uses: Epoxy.com #893 is specially formulated as a primer for our polyurethane based coatings and joint sealants. Epoxy.com # 893 will set up to form a sound surface for polyurethanes to adhere to. Epoxy.com #893 has excellent adhesion to concrete, metal, and wood.
Color: Milky liquid, which dries clear.
Sizes: 1 1/2 gallon kits and 4.5 gallon kits.
WARNINGS AND HAZARDS:Before using the products, always refer to MSDS for important warnings and safety information. Use only in areas with adequate ventilation. Avoid breathing vapors. Keep away from heat and flame. Avoid contact with eyes and skin. In the event of skin contact, remove immediately and wash with warm, soapy water. Wear suitable eye protection. Always wash hands before eating.
All surfaces which are to be coated with Epoxy.com # 893 must be free of contamination such as curing compounds, concrete hardeners, bond breakers, paint, etc. We recommend water-curing concrete instead of using concrete curing compounds. All surfaces must be clean, dry and sound. Do not apply over damp concrete. Sandblasting is recommended when possible, otherwise acid etching and wire brushing may be sufficient.
Coverage: 250 sq.ft. per gallon on porous surfaces. Up to 350 sq.ft. per gallon on smooth surfaces.
Do not over apply the primer. All water must be allowed to evaporate before application of the deck coating or joint sealant. For best results, the surface that has been coated with Epoxy.com #893 should be coated over within 8 hours. If for some reason the primer is allowed to totally cure to a hard glass-like finish, the surface should be sanded and reprimed with another coat of Epoxy.com #893 before coating over with our deck coatings or joint sealant. Epoxy.com #893 may be applied by brush, roller or spray.
Clean Up: Clean tools with detergent and water. Use disposable roller cover and discard properly after use.
Satisfactory results depend not only upon quality products but also upon factors beyond our control; methods of application and site conditions are examples of such factors and can affect product performance. This warranty consequently extends only to products installed in strict accordance with the manufacturer’s specifications. It is the users responsibility to satisfy himself, by his own information and tests, of the suitability of the product for his own intended use; user assumes all risk and liability resulting from his use of the product. The substrate to which the product is applied must be sound structurally and otherwise. Structural or substrate failures or imperfections resulting in damage to or failure of the product are not covered by this warranty.
Since the use of the product is beyond the control of the manufacturer, the manufacturer assumes no liability for misapplication and misuse of the product.
This warranty does not cover consequential damages, nor does it cover the labor attendant to replacing product in the event of a product failure. The warranty only extends to replacement of the product itself. All products proven to be defective in manufacturing will be replaced at no charge. Since the use of these products is beyond our control we cannot assume any risk or liability for results obtained, nor can we accept damages in excess of the purchase price of these products.
TECHNICAL SERVICES - All of the latest updates to product data and specifications are available on the Epoxy.com website at www.epoxy.com. Since product data and specifications change, it is the users’ responsibility to make certain the most current versions of product data and specifications are being used.